Klaristek supports document preparation, organisation, tracking and completeness review based on the information provided by the client. Work output depends on the documents, data, scope of work, SOPs, drawings, BOMs, schedules, registers and instructions supplied by the client or authorised receiver.
The client or receiver must review, verify and approve all information before finalising, issuing, purchasing, submitting or using the documents for operational, commercial, compliance or technical decisions.
Typical document flow: Preliminary Information first, then Review Version for client checking, then Final Version after client comments, approvals and required source information are received.
Final technical approval, engineering certification, compliance sign-off, weld acceptance, inspection acceptance and design responsibility remain with the client's authorised engineer, QA representative, inspector, certifier or nominated responsible person.
Klaristek does not accept confidential employer documents, restricted client files or work that creates a conflict of interest. Engagements should be confirmed in writing before work starts.
This page is general information only and is not legal, engineering, tax or compliance advice.